To install the seat occupancy sensor emulator:

1. Turn the ignition OFF.

2. Locate the mat connector which is under the passenger's seat - black 4 way plug with 3 wires: white, brown and red.

3. Disconnect the mat plug and replace original seat occupancy sensor wires with the emulator's wires.

 

The next step is the installation of the seat belt emulator:

1. Turn the ignition OFF.

2. Locate the seat belt buckle plug. 

 

3. Disconnect the seat belt plug and replace original seat belt buckle wires with the emulator's wires.

ATTENTION!

If the emulator is installed you MUST NOT use child seats in the front seat! IN CASE OF A COLLISION AIRBAG WILL WORK!

IMPORTANT INFORMATION

After the installation, remember to delete the error using proper diagnostic software. When the emulator is plugged it does not mean that all the warning lights go off automatically.

The emulator helps only in the situation when the seat occupancy sensor is faulty. 

If something else is faulty the emulator does not solve the problem. If an airbag control unit or a car electric installation do not work, the emulator will not help.

Every unit is tested before shipping – all of them work properly.

The emulator is a diagnostic device to check if the car installation works properly and to check if the error displayed on a dashboard is caused by a faulty mat. The emulator is only for testing – to check if the car installation works properly. If you make it a permanent solution you take responsibility for it.

When installing the emulator it does not matter if the passenger is on the seat - airbag reliably fulfill its functions even without a passenger, that is going to work even when passenger seat is vacant.